Original Part
General Purpose Digital Isolator 2500Vrms 1 Channel 100Mbps 25kV/µs CMTI 8-SOIC (0.154", 3.90mm Width)
Alternative Part
General Purpose Digital Isolator 3750Vrms 1 Channel 150Mbps 35kV/µs CMTI 8-SOIC (0.154", 3.90mm Width)
General Purpose Digital Isolator 3750Vrms 1 Channel 15Mbps 35kV/µs CMTI 8-SOIC (0.154", 3.90mm Width)
1. SI8610EC-B-ISR Substitution Conclusion
This device is a viable substitute and represents a performance upgrade, though careful attention must be paid to timing and signal integrity differences at high speeds. Compared to the ISO721D, the SI8610EC-B-ISR offers improvements across key parameters: isolation voltage is increased from 2500Vrms to 3750Vrms, providing a higher safety insulation rating; data rate is enhanced from 100Mbps to 150Mbps, supporting higher-speed signal transmission; common-mode transient immunity (CMTI) is improved from 25kV/µs to 35kV/µs, resulting in more robust performance in noisy power electronics environments. It also features a wider supply voltage range (2.5V to 5.5V), offering better compatibility. While its propagation delay is shorter (13ns vs. 24ns), its rise/fall times are longer (2.5ns vs. 1ns). This will alter system timing margins and may cause more pronounced signal edge rounding at very high frequencies, necessitating re-validation of timing and signal integrity in the design.
2. SI8716BC-A-IS Substitution Conclusion
Direct substitution is not recommended. This device is suitable only for low-speed applications due to an order-of-magnitude difference in data throughput capability. Although the SI8716BC-A-IS offers superior isolation voltage (3750Vrms) and CMTI (35kV/µs) compared to the original part, its core data rate is only 15Mbps, which is far below the ISO721D's 100Mbps. This fundamentally prevents it from handling medium- to high-speed digital signals. Furthermore, its propagation delay (50ns) and pulse width distortion (25ns) are significantly worse than those of the original part, leading to greater signal transmission latency and poorer timing accuracy. This part can only be used for isolating very low-speed control signals (e.g., low-speed GPIO, relay drives). If used as a direct replacement in an original 100Mbps design, communication failure or bit errors are inevitable.
Analysis ID: DA21-AA88000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com