Original Part
30 Ohms @ 100 MHz 1 Power Line Ferrite Bead 0603 (1608 Metric) 3A 30mOhm
Alternative Part
26 Ohms @ 100 MHz 1 Power Line Ferrite Bead 0603 (1608 Metric) 3A 30mOhm
25 Ohms @ 100 MHz 1 Power Line Ferrite Bead 0603 (1608 Metric) 3A 30mOhm
1. BBPY00160808260Y00 Substitution Conclusion
From a review of key parameters, this part exhibits identical specifications to the original part PZ1608U300-3R0TF in three metrics critical for power integrity: package size (0603), rated current (3A), and maximum DC resistance (30mOhm). This ensures direct drop-in replacement on the PCB and equivalent performance in terms of temperature rise and voltage drop under the same load conditions. The deviation lies in its impedance @100MHz, which is 26Ω, approximately 13% lower than the original part's 30Ω. Consequently, its attenuation of high-frequency noise around 100MHz will be slightly weaker. If the original design has sufficient noise attenuation margin at the specific frequency band, this variance is generally acceptable. However, for noise-sensitive circuits or precise filtering applications, an assessment is required to determine whether this change in attenuation could impact the system's EMC performance.
2. BBPY00160808250Y00 Substitution Conclusion
This part is highly similar to the BBPY00160808260Y00 case. Its core specifications—package, current handling capability, and DCR—are fully matched with the original part, satisfying the fundamental physical and electrical requirements for substitution. The variance, again, is in the impedance characteristic. Its value @100MHz is 25Ω, which is 16.7% lower than the original part. This indicates a further reduction in high-frequency impedance, resulting in weaker noise attenuation capability compared to both the original part and the other substitute. In general power decoupling or broad-spectrum filtering applications, this difference may not be significant. However, on filter nodes specifically optimized for particular high-frequency noise (e.g., clock harmonics), careful verification is necessary to ensure the post-substitution noise suppression remains within the design tolerance limits.
Analysis ID: 338D-AB26000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com