Original Part
Alternative Part
1. FMAT7463-20 Substitution Conclusion
The FMAT7463-20 can serve as a conditional, downgraded substitute. It matches the original part (SA18S10W-20) in all key electrical parameters, including attenuation value, power rating, and impedance. The critical difference is its frequency range, which has an upper limit of 12.4 GHz compared to the original's 18 GHz. If your application system operates at or below 12.4 GHz, the FMAT7463-20 is a fully equivalent drop-in replacement in terms of electrical performance. However, for systems requiring operation between 12.4 GHz and 18 GHz, this part cannot guarantee the specified attenuation accuracy and port matching performance. Therefore, it is essential to verify the system's actual maximum operating frequency prior to substitution.
2. SA6S10W-20 Substitution Conclusion
Substitution with the SA6S10W-20 carries high risk and is only recommended as an extreme downgrade replacement for confirmed low-frequency applications. The primary variance from the original part is again the frequency range, with an upper limit of only 6 GHz, significantly lower than the original's 18 GHz. Above 6 GHz, the attenuator's performance will degrade severely (attenuation deviation, increased VSWR), potentially leading to system signal distortion or performance degradation. Substitution is not advised unless you can guarantee with 100% certainty that the system will never operate above 6 GHz, and any future bandwidth upgrades are precluded. Additionally, its package is listed as "SMA 1.2," which may present subtle mechanical interface differences compared to the original "SMA 1.3" connector. Physical fit and compatibility should be verified during installation.
Analysis ID: E641-13D4000
Based on part parameters and for reference only. Not to be used for procurement or production.
SkyChip © 2026, Email: sales@skychip.com